Scorched cashew pieces are halves, butts and bits of cashew kernels darkened from too much factory heat, graded as SB, SS, SP and SSP. The kernel is the nut from inside the cashew shell. These four codes make up section E of the Indian trade grade chart of cashew grades, between the white and dessert piece sections.
The four scorched piece grades

Each of the four grades has its own shape or size rule, and all four share one colour rule. The Indian trade grade chart describes the colour as scorched or slightly darkened from overheating in roasting. It also names drying in a drier or borma, the conventional factory dryer for shelled kernels. The table lists each rule and limit.
| Code | Name | Shape or size | Broken bits allowed | Lower grade allowed |
|---|---|---|---|---|
| SB | Scorched butts | A kernel broken across, halves still joined | 5% | 7.5% DB |
| SS | Scorched splits | One half of a kernel that split along its length | 5% | 7.5% DS |
| SP | Scorched pieces | Bits that remain on a 4.75 mm sieve | None | 7.5% SSP and SPS together |
| SSP | Scorched small pieces | Bits smaller than SP that remain on a 2.80 mm sieve | None | 5% DSP |
SB and SS have no count per pound, and SP and SSP use sieves in place of a count. SB, SS and SP cap moisture, the water inside the kernel, at 5%. DB, DS and DSP are dessert butts, dessert splits and dessert small pieces, and the Indian list names them only inside these limits. In a 1 kg bag of SP, up to 75 g may be SSP and SPS. A 1 kg bag of SSP may hold up to 50 g of DSP, a smaller share than the other three codes allow.
Sieve sizes for SP and SSP
Two sieves divide the bits into SP and SSP: one with 4.75 mm holes and one with 2.80 mm holes. A bit that remains on the 4.75 mm sieve is SP. One that falls through those holes but remains on the 2.80 mm sieve is SSP. Anything smaller belongs to neither grade.
ISO 6477 uses the same two holes for its SP and SSP grades. White grades share the sieves too. LWP matches the SP size, and SWP matches the SSP size, as the NutDana Insight on splits, LWP and SWP shows for the white side.
Vietnam TCVN 4850 sizes these pieces on the same two hole widths. Its sieves have round holes, which the US AFI rules bar for sizing pieces. A lot sold under both rules needs a check on a round hole sieve and a woven wire sieve.
Heat and breakage in one piece
A scorched piece has two visible traits: darker colour and a break. The grade lists name two heating steps behind the colour:
- Indian list: roasting, or drying in a drier or borma
- US AFI rules and the two East African drafts: shelling or blanching, a short heat treatment
Heat also makes kernels easier to break. Processing conditions affect colour and breakage. Infrared drying research studied kernel quality under different heat settings. Excessive heat can darken the kernel; a break during later handling can then create a scorched piece.
Sorting scorched pieces from white pieces
Colour decides if a broken bit goes to a white grade or a darker one. Three methods sort pieces for colour:
- Hand sorting: workers pick out darker bits on sight, a common method in Tanzania.
- Computer models: on photos of 812 kernels, 402 scorched and 410 white, the best model named the colour right for 99.8%.
- Optical sorters: these machines check each falling kernel with a camera and remove scorched nuts and other defects.
Long roasting in steam chambers and over-drying cause the light brown colour that each method picks out.
Scorched piece rules in each standard
Six standards print rules for these grades, and four of them use all four codes: SB, SS, SP and SSP. The table compares codes, the name for SSP, limits and colour words.
| Standard | Codes | Full name of SSP | Lower grade limit | Colour |
|---|---|---|---|---|
| Indian trade grade chart | SB, SS, SP, SSP | Scorched small pieces | 7.5% for SB, SS and SP; 5% for SSP | Scorched or slightly darkened |
| ISO 6477, 1988 | Grades XVI to XIX | Scorched small pieces | Absent from the public extract | Light brown or deep ivory |
| NC 1:2018, East African draft | SB, SS, SP, SSP and kernel powder | Second scorched pieces | 5% of next lower grade or pieces | Light brown or deep ivory |
| DUS 1704:2017, Uganda draft | SB, SS, SP, SSP and kernel powder | Scorched small pieces | 5% of next lower grade or pieces | Light brown or deep ivory |
| TCVN 4850:2010, Vietnam | Grades 25 SB, 26 SS, 31 LSP, 32 SSP | Small scorched piece | 5% of next lower grade; 5% broken | Same as the scorched whole grade |
| US AFI, 2023 | No scorched piece codes | None | 5% of the next lower piece size | Second Quality Scorched colours, the list used for scorched wholes |
ISO 6477 also bars insect damage, black spots and testa on these pieces. Testa is the thin brown skin of the kernel. Both East African drafts allow 10% of the next lower grade in dessert pieces, twice the scorched figure. In the Uganda draft, kernel powder comes from deliberate breaking or from hand peeling, and may be white, light brown or brown. TCVN also lists LSSP and SSSP, large and small pieces one colour step down, as second scorched. AFI adds a Lightly Blemished Pieces class. In it, light brown speckles may mark up to 20% of the pieces.
What SP, SS and SSP can mean on a pack
The same code can name different grades on different lists. A pack label makes sense only next to the list behind it. The table sets the main meaning of each code beside other uses on packs and lists.
| Code | Meaning on grade lists | Other uses on packs and lists |
|---|---|---|
| SP | Scorched pieces | Small pieces of any colour in Vietnam TCVN 4850 and an Irish spec sheet |
| SS | Scorched splits | Second scorched, a darker colour step, in the TCVN code table; scorched seconds or second split on some Indian wholesale packs |
| SSP | Scorched small pieces | Second scorched pieces in the NC 1:2018 draft |
The Indian list, ISO 6477, both East African drafts and Indian customs all use SP for scorched pieces.
Food-service packs in India also print piece counts beside these codes, such as SSP (4 Pieces) and SS (2 Pieces). No grade list sets a piece count for these grades.
A pack may describe scorched pieces as lightly roasted for flavour. The AFI rules define scorching another way: discolouring from overheating during shelling or blanching, at the factory. Cashew Nuts (Kaju) covers roasting for sale, a later step.
Scorched pieces in customs and BIS records
Indian customs and the Bureau of Indian Standards (BIS) both treat scorched pieces as a category of their own.
A 2012 notice from Jawaharlal Nehru Custom House at Nhava Sheva lists six kernel categories for importers to declare. Scorched pieces form one of them, with SB, SS, SP and SSP as its grades. Each bill of entry, the import form, must also state the count per 454 g, the colour and the origin.
The BIS product manual for IS 7750, revised in 2021, ranks white above scorched and scorched above dessert. It also ranks wholes above pieces. A lab pass for one scorched piece grade can extend a licence to the other scorched and dessert piece grades.
Weighing a scorched piece sample
A kitchen scale, a 200 g sample and two sieves test an SP or SSP lot against the Indian limits.
- Ask the seller which grade list the code on the pack follows.
- Take a 200 g sample in three scoops: one near the top, one in the middle, one near the bottom.
- Shake the sample on a 4.75 mm sieve, then shake whatever falls through on a 2.80 mm sieve. Set aside anything that passes both.
- For SP, weigh the bits from the 2.80 mm sieve with any shrivelled, speckled or darker pieces. Up to 15 g meets the 7.5% limit.
- For SSP, weigh the pieces with dessert faults, such as deep brown colour or black spots. Up to 10 g meets the 5% limit.
- For SB or SS, weigh loose bits and dessert kernels apart. Up to 10 g of bits and 15 g of DB or DS pass.
Smell and other checks for large orders appear in the bulk buying checklist.
Short answers on scorched pieces
Do scorched pieces include dessert pieces?
No. The Indian list prints dessert pieces in a section of their own: SPS, DP and DSP. SPS, or scorched pieces seconds, belongs there despite its name. DP pieces may show deep scorching, deep brown or blue colour, speckles or black spots.
What foods use scorched cashew pieces?
Grade lists name no use. A food-service SS pack in India lists garnishing, kaju sweets, snacking and roasting as uses.
Does NutDana sell scorched cashew pieces?
No. NutDana sells W180 to W450 wholes and four broken grades: JH, JK, LWP, and SWP or baby bits. The range holds no scorched grade.
Sources and further reading
- Cashew grade charts, All India Cashew Association
- ISO 6477:1988 Cashew kernels: Specification, sample pages
- Northern Corridor NC 1:2018 Cashew kernels: Specification (WTO notification)
- Uganda National Bureau of Standards: DUS 1704:2017 Cashew kernels, draft (WTO notification)
- VINACAS: TCVN 4850:2010 Specification for cashew kernels, Vietnamese and English
- AFI: Cashew kernel specifications, updated September 2023
- Jawaharlal Nehru Custom House: Public Notice 63/2012, declaration of full description of cashew kernels
- Bureau of Indian Standards: Product manual for cashew kernels, IS 7750, revised 2021
- Hebbar and Ramesh: Optimisation of processing conditions for infrared drying of cashew kernels with testa, CFTRI, 2005
- Baitu, Gadalla and Öztekin: Traditional machine learning-based classification of cashew kernels using colour features, Journal of Tekirdag Agricultural Faculty 20(1), 2023
- TOMRA: Cashew optical sorting machines
- Code and pack names: Nuts in Bulk SP specification, Hyperpure SS (2 Pieces), I Traders, Coimbatore, Hyperpure SSP (4 Pieces), Hyperpure SS (2 Piece) tin
